|   English version | Datasheets 
KAZUS.RU -  .  , Datasheets,

MAKITA DC1414t circuit circuit

    
: Infrared control system



: 220     : 71 - 80

Oscillator circuit to find value of transistor ft
Category:
Source: Amateur-Circuitry
Circuit of linear-scale capacitance meter
Category:
Source: Amateur-Circuitry
Circuit diagram of the simple direct-reading capacitance meter
Category:
Source: Amateur-Circuitry
Circuit of linear scale resistance meter
Category:
Source: Amateur-Circuitry
The amplifier and detector circuit
Category:
Source: Amateur-Circuitry
Noise diode circuit suitable for unbalanced input
Category:
Source: Amateur-Circuitry
Noise diode circuit suitable for balanced input
Category:
Source: Amateur-Circuitry
Stepping Motor Driver - Minimalist circuit uses one CMOS gate and is reversible
Category:
Source: Interesting Schematics - Novotill
UNIPOLAR STEPPER MOTOR CONTROL CIRCUIT. This circuit controls a small, four-phase, five-wire, unipolar stepper motor, commonly designated the "KP4M4-001." This type of motor was used in many 5 1/4" floppy disk drives in older computers. Now obsolete, such disk drives are often available on the surplus market for a small fraction of the motor's original cost. The stepper motors are easy to extract from the drives, and are ideal for many applications. This arrangement was used in the scale model of a RADAR set to control the position of a miniature parabolic antenna. (Note that some 5 1/4" floppy disk drives used a four-wire "bipolar" motor, which is not compatible with this circuit.)
[ rar ] - WinRAR
Category:
Source: Art's Theremin Page
BIPOLAR STEPPER MOTOR CONTROL CIRCUIT. In this circuit, a potentiometer controls both the speed and direction of a small bipolar stepping motor like those found in many 5 1/4" floppy disk drives. Note that the bipolar motors are distinguished from "unipolar" types, in that bipolar units have two coils instead of four, and four wires instead of five. With the potentiometer at the extreme counterclockwise position, the motor runs counterclockwise at the maximum speed. Rotating the potentiometer toward the center slows the motor, until it stops. Continuing potentiometer rotation clockwise, the motor starts to run clockwise, increasing in speed to the maximum clockwise position.
[ rar ] - WinRAR
Category:
Source: Art's Theremin Page
[1] [2] [3] [4] [5] [6] [7] 8 [9] [10] [11] [12] [13] [14] [15] [16] [17] [18] [19] [20] [21] [22]

[06/02/2019] . 2019
[09/05/2018] Gearbest!
[16/05/2017] 15 17 Gearbest
[10/05/2017] ?
[05/12/2016] GearBest!
>>
PDA - , / // C/IR - / Electronic circuits Datasheets
icrocontrollers
Drivers for LED dispays Data Logger for iButton LCD-module with MCS-51 Thermometers Dallas Semiconductor Work with EEPROM 24LCxx MSP430 with Flash-memory ATmega169 and AVR-Baterfly CAN interface USB interface
Arduino , ...
:
: 0
: 2
: 144272

:

 © 2003—2021 « »@